Yes, I have a Multiverse Resonator. It's really just a Hyper Dimensional Resonator built into a copper pyramid. I built it so long ago, I don't exactly remember when. But I never completed it until recently. The problem was the time coils. Consulting with HDRKid helped me resolve that problem. Apparently the time coils are to be made with guitar cord. But in the original schematic it says to use blue phone cord. Blue phone cord didn't work because the wires were so fine, the connections easily broke. So my Multiverse Resonator has been sitting in my closet all these years unfinished. But just recently I decided to make a Hyper Dimensional Resonator. So now I have a completed HDR with the electromagnet and time coils. But the HDR doesn't seem to me to be performing as it should. So I decided to connect the electromagnet and the time coils to my Multiverse Resonator to see how it performs with the copper pyramid construction. So everything was connected. I turned on the power and BANG! I had to think quick. I pulled the cord. Then I realized what happened. The electromagnet had pulled a few of the tools on my work bench toward it, making a very startling sound. This electromagnet seems to be just as powerful as a large neodymium magnet I happen to own. A warning comes with my neodymium magnet. It says the magnet is strong enough to break the bones in my hand if I sould get in the way of something being attracted to the magnet. Well it looks like I now own an electromagnet that is just as dangerous. I measured the amperage used by the electromagnet when plugged into the Multiverse Resonator. 6.25 amps. That is way more than it should be drawing. I don't understand why just yet. I'm not quite ready to admit the the copper pyramid is causing the boost in current consumption. So I will be doing some experiments to see if I can figure out whats going on. But I did a comparison amperage draw with my HDR. It uses the same electrical circuit. But only draws about a third of an amp. Now I think that is too low. So currently I've looked over the construction of both machines and I did find something odd. The diodes in the Multiverse Resonator look like Radio Shack diodes. But the part numbers on the diodes indicate they are not. So it might be the diodes that are causing the big difference in the electromagnets performance. Today I made a trip down to an electronics surplus store and got a hold of some diodes very similar to what is in the Multiverse Resonator. I plan to put these diodes in my HDR just to see if I can up the current used by the electromagnet. Well I made a video for everyone to see my new electromagnet hooked up to my Multiverse Resonator.