3 6 9 Theory Of Nikola Tesla, The Universe Secret Code..

been collecting some sine wave to square wave convertor circuits to try convert all my sine wave frequencies into square waves but the two ive collected so far were drawn up by idiots with half a brain the circuits there but no details on the parts used or what they are , its like building a skeleton and not bothering to put the flesh in it to make it humen errr
 
also havent got a scalar beam receiver with audio to even know if its works sending signals with a morse code key with a morse code key you can hear the taps even without a receiver with audio to know its working, but using a switch and no scalar wave receiver try hearing a push button switch taps you cant as it has that spring inside and the conductive contacts are to soft and not hearable
 
Date is now the 29-3-2022



ive repeated the scalar beamer experiment, and in the rush i forgot to conect a wire to the variable sqaure wave generators output, but when i did it all went ok, the motor dident upright itself onto its shaft end this time , so i gave it a hand and it stayed there , while spining and when i take my finger off the switch in the neg wire to the motors negative input terminal, the motor would then drop down onto its side , i was having problems with the mess of wires in the way and one come off so i had to resolder it back onto the scalar beamer coil, and i adjusted the frequency of the square wave generator and got my pc to continiuously reset as you can hear its usb plug in and plug out sound, my pc did turn off by itself , i know i didnt turn it off and i set my camcorder up and captured video of the motor spining on the end of its shaft but with one of the wires being a bit short and pulling the motor towards the scalar beamer magnets i had to make it longer to keep it away more thurther , and when i conected my camcorder to my pc to load the video i shot the battery in it was mystieriously drained flatt ,usually the power lasts a while before it goes flatt if you dont use it for a while , and i tested the flasher led by turning it off while the pc usb plug in plug out audio was continiuously resetting itself, whether the flasher is on or off, turns out the flash made no difference really even though you can hear the difference when you power a pizeo speaker with it so it must be assisting in something else yet unknown to me, and since changing one of the wires so i can have the electric motor thurther away from the scalar beamers magnets it worked great , and so adjusting the square wave generators frequency dose magic in the experiment .



And ive got the parts to bread board a prototype sine wave to square wave convertor so i can test all my sine wave frequency generators with it to search for any thing that dose wonders in my experiments .



If i can find my plug sockets ill try runing my pc audio to my black star amp and see if it can amp up the usb plug sounds more so i can capture it with my camcorder mike . As the sounds are to faint and yet somtimes its louder so i dont know what the unknown factor is there yet.
another thing i forgot to mention before i extended one of the motor wires that runs to the scalar beamer to keep the motor away from the magnets everytime it got pulled into the magnets it never touched it, it kepet an inch away as if its pulling it in and repelling it away so it never it stays an inch away which is a bit off as to why a magnet that pulls the motor in dosent conect to its magnets but keeps a distance , is bizzare and new to me
 
Last edited:
heres a new video shot of the experiment , the motor didnt stand up by itself so i gave it a hand

what is keeping the electric motor upright despite 2 wires hanging off the positive motor terminal input and one negative wire on the negative motor terminal
 
maybe the scalar beamer output is acting like a tractor beam holding it upright and in other experiments i had to extend the positive leed wire out of two as it was to short and it was getting pulled into the scalar beamers magnetic attraction but sometimes it stays an inch away without sticking to the scalar beamer
 
yes and it just goes all over the place and is unstable and drops on its side, it wont stay up by power alone unless its runing through the scalar beamer and being fed the variable square wave frequencies, now i just have to try get it to levitate so i have a few ideas to try out in time
 
unlike the tesla zero point generator that was said to lock onto the rotation of the earth this seems to act like its locked onto the core of the earth thus balancing on its spindle like its locked pointing down towards the core of the earth or the whole set up is creating some standing wave locked to the core and positioning itself inline with it is just a geuss . but it should not be able to do what it dose , with a gyroscope like stabilization.
 

Top