🧲 Schematic Schematic for modified and working Dr. Bob Beck Brain Tuner (tested).

brain zapping there's a video online about it anyhow my modified Rochelle salt crystals all found to contain information images even alien and the latest a girl on a horse so i melted them down filled the coper pipe electrodes with them and they act like they have some kind of intelligence. and more, for a parasite zapper these would be best for them
 
Someday I might experiment with salts, but if you have an oscilloscope, I'd ask that you post some traces to see the differences I mentioned. They have me curious. My current project is an MWO, and I'm way behind schedule with it as my health problems keep acting up.
 
heres a fresh redraw of my schematic and it pulses the frequencies you feed it and its super easy to build from my super simple schematics modifying Rochelle salt crystals before i melt them down to fill the electrodes ill do a detailed explanation of it latter
 

Attachments

  • frequency pulsar drawing 2.webp
    frequency pulsar drawing 2.webp
    1.9 MB · Views: 3
MODAT7 said:
Someday I might experiment with salts, but if you have an oscilloscope, I'd ask that you post some traces to see the differences I mentioned. They have me curious. My current project is an MWO, and I'm way behind schedule with it as my health problems keep acting up.
Click to expand...
yes ive uploaded a video on my channel before of the waveforms i got from my modified Rochelle salt crystal electrodes by themselves after running my frequency generator through them
 
I've seen some odd waveforms with highly capacitive and inductive loads. This one doesn't look to be driven symmetrically. It looks like your square waves are clipping on the scope display. Keeping your scope in the DC mode will bypass the probe capacitors and clean up the display a little. It will also show you DC offsets that might cause burns. The salt crystals are probably storing a little energy and causing some of the bouncing in the middle. There's probably a little resonance involved with the size of your pipe handles that's making it worse. The 555's weren't designed to drive triac gates, and that's likely not helping anything. Triacs don't shut off until there is a zero crossing. You should be using something like a bd139 (standard NPN that's available everywhere).
 
i recently fed a 165.2 khz dc signal into my ac frequency pulsar circuit it wont do it unless is ac , the frequency i fed it was from my 12 volts dc nausea generator circuit that didn't work with any piezo or even ultrasonic speaker but it sure works with a heavey 40 kilohetrz ultrasonic transducer and it handles the frequency greatly in fact its so loud just put it against the skin near your ears and listen to it loudly right through your head and it bypasses the ears easily like i emagine those voice to skull devices. my relay version pulser would enable me to pulse any dc signal easy
 

Top