Phil Wainwright
Junior Member
- Messages
- 76
Well, the 10MHz oscillator is all together and running now. Isn't it mad how I can buy a full component set including components for less than I would spend on components alone without a case or PCB?
Anyhow that is done. I have printed a case for the (now) water cooled resonator.
The coils are all assembled, water path completed apart from the pump. I hope to use a high pressure fuel pump to run the cooling water. I can get one cheap from a scrap-yard
Completed all half of the connection wiring, Two screened RCA leads running 50ohm TG59 coax. These are for syncing timing pulses and allowing a range of waveforms to be offset by degrees. This means that I can rotate fields based on angles and by changing mark-space ratios and the combination of base and modulation frequencies, I should be able to produce contra-rotating magnetic fields.
The other leads completed today were the main RF power-leads... At least when I complete the hardware, I can connect it together.... (not confusing priorities, I just sometimes am waiting for components, so I will make the bits out of what I have in stock....)
In the middle of this, I have just taken on new offices today.... quadrupled the square footage of my office. I hope to get moved in to the new place over the Christmas holidays
Anyhow, more news when the next bits are done......
Anyhow that is done. I have printed a case for the (now) water cooled resonator.
The coils are all assembled, water path completed apart from the pump. I hope to use a high pressure fuel pump to run the cooling water. I can get one cheap from a scrap-yard
Completed all half of the connection wiring, Two screened RCA leads running 50ohm TG59 coax. These are for syncing timing pulses and allowing a range of waveforms to be offset by degrees. This means that I can rotate fields based on angles and by changing mark-space ratios and the combination of base and modulation frequencies, I should be able to produce contra-rotating magnetic fields.
The other leads completed today were the main RF power-leads... At least when I complete the hardware, I can connect it together.... (not confusing priorities, I just sometimes am waiting for components, so I will make the bits out of what I have in stock....)
In the middle of this, I have just taken on new offices today.... quadrupled the square footage of my office. I hope to get moved in to the new place over the Christmas holidays
Anyhow, more news when the next bits are done......